For Xbee-Pro Zb Surface Mount; For Xbee Zb Through Hole; For Xbee-Pro Zb Through Hole; Transmitters For Detachable Antennas - Digi XBee-PRO User Manual

The integrator is responsible for its product to comply with IC ICES-003 & FCC Part 15, Sub. B -Unintentional
Radiators. ICES-003 is the same as FCC Part 15 Sub. B and Industry Canada accepts FCC test report or CISPR 22
test report for compliance with ICES-003.

For XBee-PRO ZB surface mount:

Contains Model PS2CSM Radio, IC: 1846A-PS2CSM
The integrator is responsible for its product to comply with IC ICES-003 & FCC Part 15, Sub. B -Unintentional
Radiators. ICES-003 is the same as FCC Part 15 Sub. B and Industry Canada accepts FCC test report or CISPR 22
test report for compliance with ICES-003.
Note Legacy XBee-PRO SMT (Model: PRO S2C; hardware version 21xx) has IC: 1846A-XBPS2C.

For XBee ZB through hole:

Contains Model S2CTH Radio, IC: 1846A-S2CTH
The integrator is responsible for its product to comply with IC ICES-003 & FCC Part 15, Sub. B -Unintentional
Radiators. ICES-003 is the same as FCC Part 15 Sub. B and Industry Canada accepts FCC test report or CISPR 22
test report for compliance with ICES-003.

For XBee-PRO ZB through hole:

Contains Model PS2CTH Radio, IC: 1846A-PS2CTH
The integrator is responsible for its product to comply with IC ICES-003 & FCC Part 15, Sub. B -Unintentional
Radiators. ICES-003 is the same as FCC Part 15 Sub. B and Industry Canada accepts FCC test report or CISPR 22
test report for compliance with ICES-003.

Transmitters for detachable antennas

This device has been designed to operate with the antennas listed in the previous table and having a maximum of
19 dB. Antennas not included in this list or having a gain greater than 19 dB are strictly prohibited for use with this
device. The required antenna impedance is 50 ohms.

Detachable antenna

To reduce potential radio interference to other users, the antenna type and gain should be so chosen that the
equivalent, isotropically radiated power (EIRP) is not more than permitted for successful communication.

Australia (RCM/C-Tick)

These modules comply with requirements to be used in end products in Australia. All products with EMC and
radio communications must have a registered RCM/C-Tick mark. Registration to use the compliance mark will
only be accepted from Australian manufacturers or importers, or their agent, in Australia.
In order to have a RCM/C-Tick mark on an end product, a company must comply with a or b below.
a. have a company presence in Australia.
b. have a company/distributor/agent in Australia that will sponsor the importing of the end product.
XBee/XBee-PRO ZigBee RF Modules User Guide
Australia (RCM/C-Tick)
225