Command Control Via The Network - Christie LWU720i User Manual

8.4 Command Control via the Network

Configure and control the projector using the network using RS-232C commands.
Communication Port
The following two ports are assigned for the command control.
TCP #23 (Network Control Port1 (Port: 23))
TCP #9715 (Network Control Port2 (Port: 9715))
NOTE
• Command control is available using only the specified port above.
Command Control Settings (&46)
Configure the following items from a web browser when command control is used.
Example: If the IP address of the projector is set to 192.168.1.10:
1) Enter "http://192.168.1.10/" into the address bar of the web browser, and select
Projector Web Control from the selection window.
2) Enter your user name and password, and then click the [OK].
3) Click the [Port Settings] on the main menu.
4) Click the [Enable] checkbox to open Network Control Port1 (Port: 23) to use
TCP #23. Click the [Enable] checkbox for the [Authentication] setting when
authentication is required, otherwise clear the checkbox.
5) Click the [Enable] checkbox to open Network Control Port2 (Port: 9715) to
use TCP #9715. Click the [Enable] checkbox for the [Authentication] setting
when authentication is required, otherwise clear the checkbox.
6) Click the [Apply] button to save the settings.
LWU720i/LHD720i/LWU620i
User's Manual - Network Guide
97
8. Other Functions
020-001293-01 Rev. 1 (10-2017)