Christie LWU720i User Manual page 107

Issue: Cannot communicate with the projector. (Wireless network) (continued)
Item to be checked
Is firewall or packet filtering set in
an access point, and so on?
Is the wireless network to
connect encrypted?
Is an encryption method which
is not supported by the projector
used?
Is signal strength of wireless
network displayed in the SSID
SCAN LIST menu weak?
Is 5GHz radio wave used?
Is the same network address set
for wireless LAN and wired LAN
of the projector?
Is the wireless network adapter
of the computer enabled?
LWU720i/LHD720i/LWU620i
User's Manual - Network Guide
Solutions
Consult with your network administrator.
Set the encryption settings of the projector
again and reconnect.
The followings are encryption methods
supported by the projector:
･ WPA2-PSK(AES)
･ WPA2-PSK(TKIP)
･ WPA-PSK(AES)
･ WPA-PSK(TKIP)
･ WEP128bit
(Available only in INFRASTRUCTURE mode)
･ WEP64bit
(Available only in INFRASTRUCTURE mode)
This projector cannot be connected to the
wireless network using the encryption methods
other than the above.
･ Put the projector close to the wireless device.
･ When the projector is near the steel door,
the radio wave may not reach to the wireless
device. In that case, keep the projector away
from the door.
･ Consult with your network administrator
because there may be an interfering wireless
device.
The USB wireless adapter (USB-WL-11N-NS)
does not support 5GHz, but only 2.4GHz.
The same network address cannot be used for
wireless LAN and wired LAN. Set a different
network address for wireless LAN and wired
LAN.
Refer to the user's manual for the computer
and enable the wireless network adapter.
105
9. Troubleshooting
020-001293-01 Rev. 1 (10-2017)