Table of Contents
Advertisement
2-2. Installation of the sewing machine
❺
❸
❷
❹
Sheet A
Sheet B
Sheet A (eight pieces) and sheet B (four pieces) are supplied with the machine as accessories.
For the sheet A, three sheets are to be used as standard for each mounting position. For the sheet B,
one sheet is to be used as standard. (The state shown in the left figure)
The sheets A and B are used for adjusting the height of the top surface of the bed. Use one more
sheet to increase the height, or use only one sheet to decrease it.
Be sure to use a short nail ❺ for sheet B. If long nail ❹ is used, the nail tip can penetrate the table
giving rise to a risk of injury.
❺
❸
❼
❽
❶
❻
❹
❺
19 mm
25 mm
1)
To prevent possible accidents caused by the full
of the sewing machine, perform the work by two
persons or more when the machine is moved.
Never hold the handwheel since it rotates.
2)
Place the sewing machine on a horizontal and
plane place when placing it and do not place
any protruding thing such as a screwdriver or
the like.
3)
Attaching the hinge seats and the support rub-
bers of the machine head
Fix accessory hinge seat ❶ supplied with the
unit on the table with wood screw ❼ and wash-
er ❽ while placing sheet plate ❻ between the
hinge seat and the table as shown in the figure.
Fix machine head support rubbers ❷ and ❸ on
the table with nails while putting sheets A (stan-
dard: 3 pieces) and sheet B (standard: 1 piece)
under the machine head support rubbers.
Use nail ❺ for sheet B and nail ❹ for sheets A.
There are two different machine head support
rubbers ❸ ; i.e., the rubber for the right and that
for the left. Be sure to check the types of the
support rubbers before fixing them.
– 3 –
Advertisement
Table of Contents
