Knee Switch - JUKI LU-2828V-7 Instruction Manual

5-4. Knee switch

WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
❶
White line
Cords of knee switch
❷
Black (No. 18) White (No. 9)
18 9
10 1
Black line
(1) Installation of the knee switch
1) Assemble the knee switch ❶ . Then, fix it on the
undersurface of the table with a wood screw ❷ .
2) Connect the knee switch ❶ to No. 9 and No. 18
pins of the machine connector 18P which is con-
nected to CN36 of the machine controller.
(2) Functions of the knee switch
❶ is pressed, the data is changed
When knee switch
over to the data on one-touch changeover 4.
(Refer to "6-2-8. One-touch utility changeover
function" p.75)
The knee lifter switch can also be used as the presser
bar lifting lever through the relevant function setting.
(When it is used as the presser lifter switch, it loses its
function as the one-touch changeover 4 switch.)
– 45 –