Chapter 5 Troubleshooting
2 Power Troubleshooting
2 Power Troubleshooting
Problem
No power even
with power switch
turned ON.
• Power cord is not
properly connected to the
outlet.
• Power cord is not
properly connected to the
power inlet.
• Input voltage is not
correct; input voltage is
greater or less than the
rated voltage.
• Correct RS-232C cable is
not used.
Cause and remedy
→
Turn off the power switch and
reconnect the power cord to the
outlet properly.
→
Turn off the power switch and
reconnect the power cord to the
power inlet properly.
→
Set input voltage within the rated
voltage (puncture voltage may
occur. Contact our service
personnel).
→
Turn off the power switch and
unplug the interface cable.
Check that power is provided by
turning on the power switch and
use the correct RS-232C cable.
60