Citizen CLP-7202e User Manual page 65

Indication
RibonOut Ribbon end
OverHeat PCB overheat
Fan stop Fan stops
OP Err Option board
abnormal
Cut Err Auto-cutter abnormal
(such as poor
engagement)
ROM Err ROM checksum error
RAM Err RAM check error
− −
System error (such as
timer or CPU
malfunction)
Description
Check the contents and clear with the Stop
key.
Install the ribbon.
Check that ribbon winds properly.
Correct the faulty setting of the print mode
(direct-thermal or thermal-transfer).
Turn off the power and reset the printer. If this
recurs, contact our service personnel.
Check for fan stop caused by the problems
such as foreign matter in the air vent.
Automatically returned if the fan turns again.
If disassembling is needed to remove foreign
matter or the problem cannot be resolved,
contact our service personnel.
Turn off the power and reset the printer. If this
recurs, contact our service personnel.
Check the contents and clear with the Stop
key.
If this cannot be cleared, turn off the power
and remove foreign matter from the auto-
cutter.
If this recurs, contact our service personnel.
Turn off the power and reset the printer. If this
recurs, contact our service personnel.
Turn off the power and reset the printer. If this
recurs, contact our service personnel.
First protect the system, then turn off the
power and reset the printer. If this recurs,
contact our service personnel.
59
Chapter 5 Troubleshooting
Corrective actions
1 Error Messages