Citizen CLP-7202e User Manual page 31

Notes when setting print start position and media stop position
Auto-cutter
Direction of media feed
←→
∆
f (Stop Pos)
• When the "AfterPnt" menu item is set to "AutoCut", the relation between print start position and
media stop position should be set to [
out of platen.
• If the absolute value to O value is larger than the absolute value to f value as the set value of [ ∆ O]
increases, the media stop position may change. However, if the absolute value to f value is smaller
than the absolute value to O value as the set value of [
not change.
• When the "AfterPnt" menu item is set to "PeelWait", the set value of [ ∆ f] should be limited; the larger
value causes labels to unexpectedly peel off.
Actual distance
29.0mm (Cut)
17.4mm (Tear)
12.8mm (Peel)
Printhead
Platen
O value
←→
∆
O (Vert Adj)
f value (NoAction)
←→
∆
f (Stop Pos)
f value (PeelWait)
←→
∆
f (Stop Pos)
f value (TearBar)
←→
∆
f (Stop Pos)
f value (AutoCut)
∆
Media sensor
Print start position: Relative value to O value
(Vert Adj)
Print start position: Relative value to O value
(Stop Pos)
∆
O ≥
f]. If the value is set so that [
∆
f] decreases, the media stop position may
29
Chapter 2 Printer Operation
3 Printer Configuration Setting Mode
Labels
Liner
∆
is set ( O)
∆
is set ( f)
∆ ∆
O < f], the media may be