Parameter Verification - Mitsubishi Electric FR-A760 Series Instruction Manual

Parameter copy and parameter verification
appears...Why?
appears...Why?
and
Appears when parameters are copied between the inverter of
more.
1. Set "0" (initial value) in Pr. 160 User group read selection.
2. Set the following setting (initial value) in Pr. 989 Parameter copy alarm release.
Pr. 989 Setting
3. Reset Pr. 9, Pr. 30, Pr. 51, Pr. 52, Pr. 54, Pr. 56, Pr. 57, Pr. 61, Pr. 70, Pr. 72, Pr. 80, Pr. 82, Pr. 90 to Pr. 94 , Pr. 158,
Pr. 455, Pr. 458 to Pr. 462, Pr. 557, Pr. 859, Pr. 860, Pr. 893.

4.30.2 Parameter verification

Whether same parameter values are set in other inverters or not can be checked.
1.
Replace the operation panel on the
inverter to be verified.
• Replace it during a stop.
2.
Screen at powering on
The monitor display appears.
3.
Press
setting mode.
4.
Turn until
appears.
5.
Press
value.
" "(initial value) appears.
6.
Turn to change it to the set value
" "(parameter copy verification mode).
7.
Press
of the verified inverter to the operation panel.
• If different parameters exist, different
parameter numbers and
• Hold down
8.
It there is no difference,
flicker to complete verification.
REMARKS
When the copy destination inverter is not the FR-A700 series, "model error (
flickers ... Why?
Set frequencies, etc. may be different. Check set frequencies.
384
Parameter read error. Perform operation from step 3 again.
Parameter write error. Perform operation from step 8 again.
flicker alternately
FR-A760-00840 or less
10
Operation
to choose the parameter
(parameter copy)
to read the currently set
to read the parameter setting
flicker.
to verify.
and
FR-A760-00840
FR-A760-01040 or more
Display
Flicker ··· Parameter verification complete!!
)" is displayed.
FR-A760-01040
or less and
100
The parameter
number read
previously appears.
Flickers for about 30s
Flickering
or