Table of Contents
Advertisement
Simrad ES80 Installation Manual
Installation summary
Installation of the ES80 is a demanding task that requires careful preparations, a number of
specific procedures, wiring and required system settings.
Context
An overall installation procedure is provided. This procedure does not describe any detailed
tasks. Refer to the relevant tasks in this manual.
Note
In order to obtain maximum safety and ES80 performance, it is very important that the
installation procedures in this manual are complied to. You must do the tasks in the order
they are described. The vessel owner must make sure that the installation shipyard holds
the applicable competence to perform the installation, and that the applicable maritime
authorities are available to verify and certify the installation.
The installation shipyard must provide all necessary design and installation drawings, as
well as the relevant work standards and mounting procedures. If required, all documents
provided by the shipyard for the physical installation of the ES80 must be approved by the
vessel's national registry and corresponding maritime authority and/or classification society.
Such approval must be obtained before the installation can begin. The shipowner and
shipyard doing the installation are responsible for obtaining and paying for such approval.
Procedure
1
Determine the physical location of the transducer (or transducers).
Necessary considerations must be taken to avoid acoustic and electric disturbances.
Note
The information in this document must be regarded as general guidelines and
recommendations only. The installation shipyard must design and manufacture
installation hardware to fit the transducer to each individual vessel.
•
Where to install the transducer, page 46
•
Acoustic noise, page 53
2
Install each transducer.
Each transducer will penetrate the hull. For this reason, this is a crucial part of the
installation.
42
416739/A
Advertisement
Table of Contents
