Table of Contents
Advertisement
4
INSTALLATION
20221065A
The unit is mounted to bulkhead or panel by three Allen
screws (2) from the front. See Figure 4-1. The head of the
screws may be covered with the three enclosed caps (1).
Figure 4-1 FU50 mounting
The handle can be screwed into the knob pointing upwards
or downwards. The knob can also be rotated directly by
hand without the handle.
Strip about 25mm (1') of the cable insulation and pull the
shield backwards. Secure the cable the same way as the
other cables in the junction unit and connect the wires in
parallel with the cable shown on Figure 4-2 using the same
color code.
Figure 4-2 FU50 connection
Installation
1 - Cover for screw head
2 - Screw M6x40
3 - Washer M6
4 - Nut M6
For part nos. ref. to
mounting kit page 17.
13
Advertisement
Table of Contents
