Installing An M.2 Card - DFI KS070-ALE39P Installation Manual

Installing an M.2 Card

The system is equipped with one M.2 socket, supporting the M.2 22x42mm
(key B) form factor. Use the following procedure to install an M.2 card:
1. Align the notch at the edge of the M.2 card with the key in the connector.
2. Insert the M.2 card into the connector.
3. Push down on the other end of the M.2 card and secure and card on the
mainboard with the provided mounting screw.
Note:
The M.2 socket supports PCIe, USB, and SATA signals and can accommodate common
mobile broadband and storage modules. For jumper settings on switching the signal
betwen SATA and PCIe, refer to "Board Layout and Jumper Settings."
Mounting screw
5
M.2 card