Prestige 334 User's Guide
30.2.8 GUI-based TFTP Clients
The following table describes some of the fields that you may see in GUI-based TFTP clients.
Table 98 General Commands for GUI-based TFTP Clients
COMMAND
Host
Send/Fetch
Local File
Remote File
Binary
Abort
30.3 Restore Configuration
This section shows you how to restore a previously saved configuration. Note that this
function erases the current configuration before restoring a previous back up configuration;
please do not attempt to restore unless you have a backup configuration file stored on disk.
FTP is the preferred method for restoring your current computer configuration to your Prestige
since FTP is faster. Please note that you must wait for the system to automatically restart after
the file transfer is complete.
30.3.1 Restore Using FTP
For details about backup using (T)FTP please refer to earlier sections on FTP and TFTP file
upload in this chapter
291
DESCRIPTION
Enter the IP address of the Prestige. 192.168.1.1 is the Prestige's default IP address
when shipped.
Use "Send" to upload the file to the Prestige and "Fetch" to back up the file on your
computer.
Enter the path and name of the firmware file (*.bin extension) or configuration file
(*.rom extension) on your computer.
This is the filename on the Prestige. The filename for the firmware is "ras" and for the
configuration file, is "rom-0".
Transfer the file in binary mode.
Stop transfer of the file.
Note: WARNING! Do not interrupt the file transfer process as this
may PERMANENTLY DAMAGE YOUR Prestige.
Chapter 30 Firmware and Configuration File Maintenance