Configuring Wan Mac; Figure 23 Mac Setup - ZyXEL Communications Wireless Router P-334 User Manual

Broadband router with firewall
Hide thumbs Also See for Wireless Router P-334:
Table of Contents

Advertisement

Prestige 334 User's Guide
Table 19 WAN: IP
LABEL
Multicast
Windows Networking (NetBIOS over TCP/IP):
NetBIOS (Network Basic Input/Output System) are TCP or UDP broadcast packets that enable a
computer to connect to and communicate with a LAN. For some dial-up services such as PPPoE or
PPTP, NetBIOS packets cause unwanted calls. However it may sometimes be necessary to allow
NetBIOS packets to pass through to the WAN in order to find a computer on the WAN.
Allow between WAN
and LAN
Allow Trigger Dial
Apply
Reset

6.6 Configuring WAN MAC

To change your Prestige's WAN MAC settings, click WAN, then the WAN MAC tab. The
screen appears as shown.

Figure 23 MAC Setup

The MAC address screen allows users to configure the WAN port's MAC address by either
using the factory default or cloning the MAC address from a computer on your LAN. Choose
Factory Default to select the factory assigned default MAC Address.
81
DESCRIPTION
Choose None (default), IGMP-V1 or IGMP-V2. IGMP (Internet Group Multicast
Protocol) is a network-layer protocol used to establish membership in a
Multicast group - it is not used to carry user data. IGMP version 2 (RFC 2236)
is an improvement over version 1 (RFC 1112) but IGMP version 1 is still in
wide use. If you would like to read more detailed information about
interoperability between IGMP version 2 and version 1, please see sections 4
and 5 of RFC 2236.
Select this check box to forward NetBIOS packets from the LAN to the WAN
and from the WAN to the LAN. If your firewall is enabled with the default policy
set to block WAN to LAN traffic, you also need to enable the default WAN to
LAN firewall rule that forwards NetBIOS traffic.
Clear this check box to block all NetBIOS packets going from the LAN to the
WAN and from the WAN to the LAN.
Select this option to allow NetBIOS packets to initiate calls.
Click Apply to save your changes back to the Prestige.
Click Reset to begin configuring this screen afresh.
Chapter 6 WAN Screens

Advertisement

Table of Contents
loading

This manual is also suitable for:

Prestige 334

Table of Contents