Chapter 27 Filter Configuration; Introduction To Filters; Figure 134 Outgoing Packet Filtering Process - ZyXEL Communications Wireless Router P-334 User Manual

This chapter shows you how to create and apply filters.

27.1 Introduction to Filters

Your Prestige uses filters to decide whether to allow passage of a data packet and/or to make a
call. There are two types of filter applications: data filtering and call filtering. Filters are
subdivided into device and protocol filters, which are discussed later.
Data filtering screens the data to determine if the packet should be allowed to pass. Data filters
are divided into incoming and outgoing filters, depending on the direction of the packet
relative to a port. Data filtering can be applied on either the WAN side or the LAN side. Call
filtering is used to determine if a packet should be allowed to trigger a call. Remote node call
filtering is only applicable when using PPPoE encapsulation. Outgoing packets must undergo
data filtering before they encounter call filtering as shown in the following figure.

Figure 134 Outgoing Packet Filtering Process

For incoming packets, your Prestige applies data filters only. Packets are processed depending
upon whether a match is found. The following sections describe how to configure filter sets.

Chapter 27 Filter Configuration

C
H A P T E R
Filter Configuration
Prestige 334 User's Guide
2 7
256