Remote Management Limitations; Figure 172 Menu 24.11 - Remote Management Control; Table 102 Menu 24.11 - Remote Management Control - ZyXEL Communications Wireless Router P-334 User Manual

Prestige 334 User's Guide
Figure 172 Menu 24.11 – Remote Management Control
Menu 24.11 - Remote Management Control
TELNET Server:
FTP Server:
Web Server:
SNMP Service:
DNS Service:
The following table describes the fields in this screen.
Table 102 Menu 24.11 – Remote Management Control
FIELD
Telnet Server
FTP Server
Web Server
SNMP Service
DNS Service
Port
Access
Secure Client IP The default 0.0.0.0 allows any client to use this service or protocol to access the
Once you have filled in this menu, press [ENTER] at the message "Press ENTER to Confirm or ESC to
Cancel" to save your configuration, or press [ESC] to cancel.

32.1.1 Remote Management Limitations

Remote management over LAN or WAN will not work when:
1 A filter in menu 3.1 (LAN) or in menu 11.5 (WAN) is applied to block a Telnet, FTP or
Web service.
2 You have disabled that service in menu 24.11.
307
Port = 23
Secure Client IP = 0.0.0.0
Port = 21
Secure Client IP = 0.0.0.0
Port = 80
Secure Client IP = 0.0.0.0
Port = 161
Secure Client IP = 0.0.0.0
Port = 53
Secure Client IP = 0.0.0.0
Press ENTER to Confirm or ESC to Cancel:
DESCRIPTION
Each of these read-only labels denotes a service or protocol.
This field shows the port number for the service or protocol. You may change the
port number if needed, but you must use the same port number to access the
Prestige.
Select the access interface (if any) by pressing [SPACE BAR], then [ENTER] to
choose from: LAN only, WAN only, ALL or Disable.
Prestige. Enter an IP address to restrict access to a client with a matching IP
address.
Access = ALL
Access = ALL
Access = ALL
Access = LAN only
Access = LAN only
Chapter 32 Remote Management