Gui-Based Tftp Clients; Restore Configuration; Restore Using Ftp; Table 96 General Commands For Gui-Based Tftp Clients - ZyXEL Communications ZyWall P1 User Manual

17.3.6 GUI-based TFTP Clients

The following table describes some of the fields that you may see in GUI-based TFTP clients.

Table 96 General Commands for GUI-based TFTP Clients

COMMAND
Host
Send/Fetch
Local File
Remote File
Binary
Abort
Refer to Section 17.3.3 on page 251
WAN.

17.4 Restore Configuration

This section shows you how to restore a previously saved configuration. Note that this
function erases the current configuration before restoring a previous back up configuration;
please do not attempt to restore unless you have a backup configuration file stored on disk.
FTP is the preferred method for restoring your current computer configuration to your
ZyWALL since FTP is faster. Please note that you must wait for the system to automatically
restart after the file transfer is complete.
Note: WARNING! Do not interrupt the file transfer process as this may
PERMANENTLY DAMAGE YOUR ZyWALL. When the Restore Configuration
process is complete, the ZyWALL will automatically restart.

17.4.1 Restore Using FTP

For details about backup using (T)FTP please refer to earlier sections on FTP and TFTP file
upload in this chapter.
1 Launch the FTP client on your computer.
2 Enter "open", followed by a space and the IP address of your ZyWALL.
3 Press [ENTER] when prompted for a username.
4 Enter your password as requested (the default is "1234").
Chapter 17 Firmware and Configuration File Maintenance
DESCRIPTION
Enter the IP address of the ZyWALL. 192.168.1.1 is the ZyWALL's default IP
address when shipped.
Use "Send" to upload the file to the ZyWALL and "Fetch" to back up the file on your
computer.
Enter the path and name of the firmware file (*.bin extension) or configuration file
(*.rom extension) on your computer.
This is the filename on the ZyWALL. The filename for the firmware is "ras" and for
the configuration file, is "rom-0".
Transfer the file in binary mode.
Stop transfer of the file.
to read about configurations that disallow FTP over
ZyWALL P1 User's Guide
253