Appendix B - Envelope Feed Setup - Neopost HJ510C Operating Manual

APPENDIX B
Appendix B – Envelope Feed Setup
These instructions and additional feeding devices are designed to improve the feeding of
"Number 9" (#9) and "Number 10" (#10) envelopes, by providing better support to the
envelopes at the point of feed.
Additional Feeding Devices:
Two "weights" (one for #9 and one for #10 envelopes).
One "wide, rear paper guide".
Tip: The "wide, rear paper guide" can be used with all media over 7-1/2 inches in
width. For narrower media the smaller "standard" rear paper guide must be used.
THESE INSTRUCTIONS AND DEVICES ARE NOT A SUBSTITUTE FOR POORLY
MANUFACTURED ENVELOPES.
ENVELOPES THAT ARE SEVERELY TWISTED OR DO NOT HAVE SQUARE
CORNERS WILL STILL PRODUCE POOR FEEDING.
ALL ENVELOPES SHOULD BE FANNED BEFORE LOADING IN THE PRINTER.
1. Slide the adjustable side
guide approximately 10
inches away from the
stationary side guide; to
provide room for the
"wide, rear paper guide".
2. Remove the "standard"
rear paper guide.
Set this guide aside. It will
be used when feeding
media narrower than 7-1/2
inches.
3. Install the wide, rear paper
guide.
© 2009 Neopost USA Inc. All rights reserved.
NOTICE
39