Table of Contents
Advertisement
4. Insert one envelope under
the sheet separators and
adjust the two outer
separators to the envelope
thickness. Do not use the
center separator.
5. Place a small stack of
envelopes in the printer
and position the adjustable
side guide to within 1/32"
of the envelopes.
6. Adjust the rear paper
support so that it is
centered on the stack of
envelopes and the height
of the rear paper support is
set to its middle position,
as shown.
Adjust the "wide, rear paper guide" so the first envelope is at the bend in the guide, as shown.
7.
8. Load envelopes to the
top of the side guides
and then place the
appropriate weight on
top of the pile.
There are two weights,
one for #9 and one for
#10 envelopes.
These weights keep
pressure on the pile and
help feeding. They are
designed to permit
feeding of the last
envelope in the stack
without the weight
feeding into the printer.
40
© 2009 Neopost USA Inc. All rights reserved.
APPENDIX B
Advertisement
Table of Contents
