Table of Contents
Advertisement
SECTION 5
TROUBLE SHOOTING
LED Status
CANCEL LED is flashing
All LEDs are flashing
PAPER LED is flashing and
CANCEL LED is flashing
© 2009 Neopost USA Inc. All rights reserved.
Possible Cause
Both ink cartridges are missing.
Improperly installed cartridge(s)
or wrong print cartridge installed.
Problem with cartridge.
Printer needs to be restarted
Paper mismatch: The paper
width does not match the paper
size in the driver setting
Possible Solution
1.
Open the top cover on the printer.
2.
Install missing cartridges.
3.
Close the top cover on the printer.
1.
Open the top cover on the printer.
2.
Remove cartridge(s) and check to be sure
sealing tape was removed from cartridge
nozzles.
3.
Check that the correct cartridge(s) were
installed.
Correct Cartridges = C6657A (color) and
C6656A (black).
Do NOT use C8857A and C8856A
cartridges in the printer.
4.
Remove sealing tape and Install the correct
cartridges.
5.
Close the top cover on the printer.
1.
Open the top cover on the printer.
2.
Remove one cartridge and close the top
cover.
If the CANCEL LED goes off, the bad
cartridge has been removed.
If the CANCEL LED continues to flash, open
the top cover, remove the other cartridge
and reinstall the first one.
If the CANCEL LED goes off, the cartridge in
the printer is the good one.
If the CANCEL LED continues to flash then
both cartridge are bad.
3.
Open the top cover and replace the bad ink
cartridge(s).
4.
Close the top cover on the printer.
1.
Stop sending the print job.
2.
Press the Soft Power button to turn off the
printer, and then press it again to turn on the
printer.
3.
If the problem persists, turn the printer off
and on again, using the Main Power switch.
4.
Resend the print job.
Do one of the following:
1.
Press the PAPER button.
2.
Set the paper size in the driver to match the
paper size being used in the printer.
37
Advertisement
Table of Contents
