Framed Panel Dimensions - Monogram ZISB36 Series Installation Instructions Manual

Design Guide - Standard Installation
1/4" (0.63 cm) FRAMED PANEL DIMENSIONS
If you choose to install framed panels, they must be cut to the
dimensions shown. The panels will slide into the frame on the
door and grille.
Non-Dispenser Models
If the custom panel is less than 1/4" (0.63 cm) thick and it fits
loosely in the door frame it can be backed up with a piece of filler
material or foam tape to improve the fit.
IMPORTANT NOTE – DISPENSER MODELS
The refrigerator is supplied with two dispenser trims, one for framed panels and one for overlay panels.
• If the panel is less than 0.250" (0.63 cm) thick, a noticeable gap may be created around the dispenser trim. Foam
tape may be applied on the door to improve the fit.
• If the panel is more than 0.250" (0.63 cm) thick, the dispenser trim cannot be secured to the door.
See Dispenser Trim Fit Example, page 13.
A
Grille Panel
Dispenser
Cutout
G
F
Fresh Food
Freezer
Panel
Panel
E
D
Dispenser Cutout
B
13-5/16"
11"
C
Side-by-Side (in inches)
A
36" Models 33-7/8
42" Models 39-7/8
48" Models 45-7/8
Door
IMPORTANT NOTE: Maximum total panel weight:
• Fresh food door panel – 75 lbs.(34.0 kg)
• Freezer door panel – 53 lbs. (24.0 kg)
• Grille Panel – 18 lbs. (8.16 kg)
The framed panel must be 1/4" (0.63 cm) nominal
thickness to fit the dispenser trim.
B C D
9 68-3/8 14-9/16
9-1/2 68-3/8 14-9/16
9-1/2 68-3/8 18-9/16
10
5/16"
Trim
Reveal
1/4"
Panel
Dispenser Cutout
Position
E F G
18-9/16 34-3/16 1-7/8
24-9/16 34-3/16 1-7/8
26-9/16 34-3/16 3-7/8
31-1000450 Rev. 1