1/4" Framed Panel Dimensions - Monogram ZIS360N Installation And Design Manual

1/4" FRAMED PANEL DIMENSIONS

If you choose to install framed panels, they must be
cut to the dimensions shown. The panels will slide
into the frame on the door and grille.
Non-Dispenser Models
If the custom panel is less than 1/4" thick and it fits
loosely in the door frame it can be backed up with
a piece of filler material or foam tape to improve
the fit.
IMPORTANT NOTE – Dispenser Models
The refrigerator is supplied with two dispenser trims,
one for framed panels and one for overlay panels.
• If the panel is less than 0.250" thick a noticeable
gap may be created around the dispenser trim.
Foam tape may be applied on the door to improve
the fit.
A
Grille Panel
F
Dispenser
Cutout
G
Freezer
Fresh Food
Panel
Panel
D
E
Design Guide
Dispenser Cutout
B
9-5/8"
C
Side-by-Side (in inches)
A
36" Models 33-7/8
42" Models 39-7/8
48" Models 45-7/8
IMPORTANT NOTE: Maximum weight for fresh food panel is
50 pounds and 30 pounds for freezer panel.
• If the panel is more than 0.250" thick, the
dispenser trim cannot be secured to the door.
See Dispenser Trim Fit Example, page 9.
The framed panel must be 1/4" nominal thickness
to fit the dispenser trim.
15-3/8"
B C D
9 68-3/8 14-9/16
9-1/2 68-3/8 14-9/16
9-1/2 68-3/8 18-9/16
7
5/16"
Trim
Door
Reveal
1/4"
Panel
Dispenser
Cutout Position
E F G
18-9/16 17-13/16 3-1/8
24-9/16 17-13/16 3-1/8
26-9/16 17-13/16 5-1/8