Setup Requirements - Angelcare AC215 Owner's Manual

16.12 Remove batteries from both units if you store
the product over 30 days because the batteries
could leak and damage the product.
16.13 Discard 'dead' batteries as soon as possible
since 'dead' batteries are more likely to leak in a
product. If a battery has leaked or vented, it should
be replaced immediately using protective gloves.
16.14 DO NOT store this product, or the batteries
provided with or identified for use with this
product, in high-temperature areas.
FCC WARNING
17. (North America Only)
17.1 Warning: Changes or modifications to this
equipment not expressly approved by the party
responsible for compliance could void the user's
authority to operate the equipment.
17.2 NOTE: This equipment has been tested
and found to comply with part 15 of the FCC
R u e l . s T h e s e i l m i s t
provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used
in accordance with the instructions, may cause
harmful interference to radio communications.
17.3 H oweve r, th e re is n o g u a ra nte e th at
inter ference will not occur in a par ticular

SETUP REQUIREMENTS

INCLUDED:
Parent Unit with Nursery Unit
Rechargeable Battery
YOU MUST PREPARE:
One hardboard (not included)
Thickness: 6 mm
Minimum dimensions:
33 cm x 33 cm
Maximum dimensions:
equal to the mattress size
IMPORTANT
The hardboard must be larger than the Sensor Pad
surface area or in the case of the
two Sensor Pads.
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment OFF
and ON, the user is encouraged to try to correct
the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between
• Connect the equipment into an
• Consult the dealer or an experienced
17.4 This device complies with the part 15 of
t h
to the following two conditions:
(1) This device may not cause harmful interference,
and
(2) This device must accept any interference
received, including interference that may cause
undesired operation.
a e r d e s g i n e d t o
IC
17.5 This device complies with Industry Canada
license-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference,
and
(2) This device must accept any interference
received, including interference that may cause
undesired operation.
1 Sensor Pad (
( -2SP) with pre-installed cord covers
WHAT YOU WILL NEED
(NOT INCLUDED):
Hardboard
-2SP of
the equipment and receiver.
outlet on a circuit di erent from that
to which the receiver is connected.
radio/TV technician for help.
e F C C R u e l s . O p r e t a o i n
VIDEO, MOVEMENT
& SOUND MONITOR
) or 2 Sensor Pads
Miniature Philips
Screwdriver
E
N
s i s u b e j t c
Tabletop stand
(for camera)
AC adapter
(for parent unit)
Split USB cable
5
AC adapter
(for camera)