Important Safety Instructions; Setup Requirements - Angelcare AC527 User Manual

• The applied nameplate is located at the product
rear enclosure.

IMPORTANT SAFETY INSTRUCTIONS

37. Sensor Pad –
• If your crib does not have a solid, stationary,
completely flat, firm surface including a spring or
slat base, place a hard board between the crib base
and the Sensor Pad, to ensure correct operation
(see specification on STEP 2).
• The Sensor Pad functions with standard crib sprung
and foam mattresses and not memory foam (partial
or full), hollow frame construction mattresses and
water beds. Please consult Angelcare if unsure of
mattress compatibility.
38. This monitor uses public airwaves to transmit
signals. The Parent Unit may pick up signals or
interference from other nursery monitors in your
area. Your monitor may even be picked up by other
households. To protect your privacy, make sure both
units are turned OFF when not in use.
39. Power cord protection - Protect the
Adapter's power cord from being walked on
or pinched by furniture or other items – Power
supply cords should be routed so that they are not
likely to be walked on or pinched by items upon or
against them, paying particular attention to cords
and plugs, convenience receptacle, and the point
where they exit from the product. The socket outlet
should be installed near the equipment and should
be easily accessible. Make sure to plug the adapter
to the socket outlet nearest to the equipment and
that is easily accessible. To disconnect from mains,
unplug the adapter.
SET UP REQUIREMENTS
WHAT'S IN THE BOX
Nursery Unit
1
Tabletop stand/Wall Mount
2
(for Nursery Unit)
2 x AC Adapters
3
Parent Unit
4
Lithium Ion Battery Pack
5
(for Parent Unit)
Sensor Pad
6
CR2450 3V Battery
7
(for Sensor Pad)
Hardware (for wall mounting)
8
WHAT YOU NEED
Hardboard, if the crib does not have
a firm surface
(see specification on STEP 2).
Drill or screwdriver (for wall mounting).
4
40. Only use attachments/accessories
and replacement parts specified by
the manufacturer. Any mounting of the product
should follow the manufacturer's instructions.
• DO NOT position this product on an unstable cart,
stand, tripod, bracket or table. The product may fall,
causing serious injury to a child or adult and serious
damage to the product.
• Use ONLY the stand sold with the product.
• Be sure replacement parts are supplied by Angelcare
and have the same characteristics as original
part. Unauthourised substitution may result in fire,
electric shock or fire.
41. Unplug this appliance during lightning storms
or when not used for long periods of time.
42. Servicing - DO NOT attempt to service
this product yourself as opening or removing
covers (except battery door) may expose you
to dangerous voltage or other hazards.
• Power Supply – see Technical Specification within
this guide.
43. Overloading - DO NOT overload wall outlets,
extension cords or integral convenience
receptacles as this can result in
a risk of fire or electric shock.
44. Nursery Unit Antenna - The antenna used
for this transmitter must be installed to provide a
separation distance of at least 8'' (20 cm) from all
persons and must not be collocated or operating in
conjunction with any other antenna or transmitter.
45. Cleaning - Disconnect all units before cleaning.
DO NOT immerse any part of the monitor
in water. Clean only with a dry cloth.
1 2
4
6
3
2X
5
7
2X
8