Angelcare AC215 Owner's Manual page 12

ADJUST SOUND LEVEL
5.3 - BATTERIES
HOW TO CHECK THE BATTERIES:
Unplug the adapters from both units.
• If the green light on the Nursery Unit
does not show, replace the batteries.
• If the Parent Unit and its screen do not
light up, recharge the batteries.
HOW TO CHARGE THE BATTERIES IN THE PARENT UNIT:
Leave the Parent Unit plugged to fully
charge the unit. Although the batteries
at 1/3 capacity works normally,
we recommend that you fully recharge them.
YOU ARE NOW READY TO USE YOUR MONITOR
The Angelcare ® monitor can be used with the pre-program factory settings
or you can also customise your settings to your preference.
DEFAULT SETTINGS
Sound Mode: ON
Speaker Volume: Level 3 (of 6)
Movement Mode: ON
Sensor Pad Sensitivity: Level 3 (of 5)
TIC: ON
Temperature Unit: Celsius
Temperature Alarm: OFF
VOX: ON
VOX Level: Level 2 (of 4)
Screen Saver Timer: ON
(after 3 minutes)
LCD Brightness: Level 3 (of 5)
Key Tone: ON
IMPORTANT
• Test your monitor before first use.
• Test your monitor regularly to ensure it is functioning correctly.
• Test your monitor every time you move the Sensor Pad to a different place.
12
Increase volume
(Up arrow)
Lower volume
(Down arrow)
PUT IN SILENT/MUTE MODE
Press the down arrow
for 2 seconds to
mute sound. Mute
icon will flash. Press
again for 2 seconds to
reactivate sound.
1/3 full
PARENT UNIT BATTERY ALARM
• Alarm activates when the batteries
need to be recharged.
• Parent Unit will emit a beep sound
every 15 seconds.
• Battery Alarm icon will show
on LCD screen.
2/3 full full