2.9.2 Serial Device Connection
The
serial
device
AFL2-W15A-N270/L325. Follow the steps below to connect a serial device to the
AFL2-W15A-N270/L325 panel PC.
Locate the DB-9 connector. The location of the DB-9 connector is shown in
Step 1:
Chapter 2.
Insert the serial connector. Insert the DB-9 connector of a serial device into
Step 2:
the DB-9 connector on the bottom panel. See Figure 2-28.
Figure 2-28: Serial Device Connector
Secure the connector. Secure the serial device connector to the external
Step 3:
interface by tightening the two retention screws on either side of the connector.
2.9.3 USB Device Connection
To connect USB devices to the AFL2-W15A-N270/L325, please follow the instructions
below.
Located the USB connectors. The locations of the USB connectors are shown
Step 1:
in Chapter 2.
Align the connectors. Align the USB device connector with one of the
Step 2:
connectors on the bottom panel. See Figure 2-29.
Page 46
AFL2-W15A-N270/L325 Panel PC
connectors
are
for
connecting
serial
devices
to
the
Step 0: