Table of Contents
Advertisement
SECTION 4. PROGRAMMING THE MACHINE
Switch 03 - Automatic printing of reports
Digit
Inclusion of part of the image on the following reports: Transmission Result Report,
Memory Storage Report, Polling Clear Report, Communication Failure Report,
0
Transfer Result Report, Transmission Deadline Report, Polling Confirmation List
No
1 to 7
Do not change these settings.
Switch 04 - Various
Digit
0, 1
Do not change these settings.
2
Automatic reduction
3, 4
Do not change these settings.
5
Restricted Access
6
Do not change this setting.
Ordering Toner
If this is set to 1, store your dealer's fax number in Quick Dial Key 32. Then, when
you need to order toner, use the procedure on page 62.
7
If you wish to use Quick Dial 32 for a number other than that of your dealer, set this
bit to 0. Quick Dial Key 32 can now be programmed in the same way as other Quick
Dial Keys. However, you will not be able to use the Ordering Toner feature.
Switch 05 - Various
Digit
0
Substitute reception
Multi-sort document reception with reverse order printing (Memory card or hard disk
1
required)
2
Do not change this setting.
3
Memory reception if no RTI or CSI received
4 to 7
Do not change these settings.
2-3. Economy Transmission Time
1.
Function
7
4
2. Input the time at which you wish Economy Transmission to take place.
3. Press
Yes
74
1: Yes
6
0
2
2
2
Function
when the display is correct.
Purpose
Purpose
0: Off
0: Off
0: Disabled
1: Enabled
Purpose
0: Off
0: Off
0: Possible
2
ECONOMY TX
TIME=
1: On
1: On
1: On
1: On
1: Not possible
11
:00
TO END
YES
Advertisement
Table of Contents
