Grundig GD-RN-CT8832N User Manual page 22

13 PTZ
14 ESC
15 RESERVED
16 F1
17 PTZ Control
18 F2
Troubleshooting the Remote Control:
Note:
Make sure that you installed the batteries properly in the remote control. You also have to aim the
remote control at the IR receiver in the front panel.
If there is no response after you press any button on the remote control, follow the procedure below to
troubleshoot.
Steps:
1. Go to Menu > Settings > General > More Settings by operating the front control panel or the mouse.
7. Check and remember the <NVR ID#>. The default <ID#> is <255>. This <ID#> is valid for all of the IR
remote controls.
8. Press the <DEV> button on the remote control.
9. Enter the <NVR ID#> you set in step 2.
10. Press the <ENTER> button on the remote control.
If the Status indicator on the front panel turns blue, then the remote control is operating properly. If
the Status indicator does not turn blue and there is still no response from the remote, please check the
following:
‒
Batteries are installed correctly and the polarities of the batteries are not reversed.
‒
Batteries are fresh and not out of charge.
‒
The IR receiver is not obstructed.
‒
No fluorescent lamp is used nearby.
Advance video a single frame in the Single-frame <Playback> mode.
Stop/start the <Auto-switch> in the <Auto-switch> mode
Enter the <PTZ Control> mode.
Go back to the previous screen.
N/A
Reserved
Select all items on a list.
N/A
Switch between Play and Reverse Play in the <Playback> mode.
Adjust the PTZ Camera iris, focus, and zoom.
Cycle through tab pages.
Switch between channels in the Synchronous <Playback> mode.
22 ENGLISH