Enable Raid; One-Touch Configuration - Grundig GD-RN-CT8832N User Manual

13.1.1 Enable RAID

Perform the following steps to enable the <RAID> function, or the disk array cannot be created.
Note:
Use the enterprise-level HDDs to create the array.
OPTION 1:

Enable the <RAID> function in the Wizard when the device starts up, please refer to step 7 of Chapter
2.2.
OPTION 2:

Enable the <RAID> function in the <HDD Management> interface.
Steps:
1. Enter the <Disk Mode Configuration> interface: Menu > HDD > Advanced.
2. Check the checkbox of <Enable RAID>.
3. Click the <Apply> button to save the settings.

13.1.2 One-touch Configuration

Through <One-touch Configuration>, you can quickly create the <Disk Array>. By default, the <Array
Type> to be created is <RAID 5>.
Before you start:
‒
The <RAID> function should be enabled, please refer to Chapter 13.1.1 for details.
‒
As the default <Array Type> is <RAID 5>, please install at least 3 HDDs on your device.
‒
If more than 10 HDDs are installed, 2 arrays can be configured.
Steps:
1. Enter the <RAID Configuration> interface: Menu > HDD > RAID
2. Check the checkbox of the corresponding <HDD No.> to select it.
3. Click the <One-touch Create> button to enter the <One-touch Array Configuration> interface.
4. Edit the <Array Name> in the <Array Name> text filed and click the <OK> button to start configuring
the <Array>.
Note:
If you install 4 HDDs or more for <One-touch Configuration>, a <Hot Spare> disk will be set by default. It
is recommended to set a <Hot Spare> disk for automatically rebuilding the <Array> when the array is
abnormal.
5. When the <Array Configuration> is completed, click the <OK> button in the pop-up message box to
finish the settings.
6. You can click the <Array> tab to view the information of the successfully created <Array>.
Note:
By default, <One-touch Configuration> creates an <Array> and a <Virtual Disk>.
170 ENGLISH