The Dishwashing Results Are Not Satisfactory - Hanseatic WQP8-7610H User Manual

Page EN-28 Troubleshooting table
Problem Possible cause
The dishwasher salt is
The LED (9)
clumpy.
is illuminated
although dish-
washer salt has
been added.
The water is There is a kink in the inlet
not running or it hose.
is running only
very slowly.
The water tap is not properly
on.
The water is not The filters are blocked.
running off or
only very slowly.
The outlet hose is kinked, has
been extended or is hanging
too high up/too low.
The dishwasher The door seal is defective.
is not watertight.
The outlet hose or the inlet
hose is defective.
The dishwasher The dishwasher can only be
can be switched operated when the door is
on/off, but not closed.
cannot be oper-
ated.

The dishwashing results are not satisfactory

Problem Possible cause
There are resi- The rinse aid is incorrectly
dues or streaks dosed.
on the dishes.
There is no dishwasher salt.
The dishwasher salt is
clumpy.
Solution
Stir the dishwasher salt using the end of a
spoon or similar.
Arrange the inlet hose properly, avoiding
kinks (see „Connecting the inlet hose" on
page EN-25).
Turn the water tap on completely.
Clean the filters (see „Cleaning the filters"
on page EN-22).
Lay out the outlet hose in the proper man-
ner (see „Having the outlet hose connect-
ed" on page EN-25).
Have the door seal replaced (see „Service
department" on page EN-30).
Have the defective hose replaced (see
„Service department" on page EN-30).
Close the door.
Solution
Adjust the dispensed dose (see „Adding
rinse aid" on page EN-12).
Add dishwasher salt (see „Adding dish-
washer salt" on page EN-13).
Stir the dishwasher salt using the end of a
spoon or similar.