Dishwasher Operation; Preparation; Select The Wash Programme; And Start - Hanseatic WQP8-7610H User Manual

Dishwasher operation

Preparation

Requirements:
– You have read chapter „Safety" on page
EN-6 and understand all the safety notices.
– The appliance is set up and connected as
described in chapter „Installation, connec-
tion and commissioning" on page EN-24.
– Dishwasher detergents, rinse aids and
dishwasher salts and multitabs are added.

Select the wash programme

and start

1. Open the tap completely.
2. Switch the dishwasher on using the On/
Off button (2). An acoustic signal sounds
and the "On/Off" display (1) lights up.
3. Search for the appropriate dishwasher
programme (see „Dishwasher programme
table" on page EN-18).
4. Press the programme selection button (4)
as many times as required for the wash
programme you want to light up in the
programme display (3).
5. Press the Start/Pause button (12)
start the wash programme.
While the wash programme is running,
the programme display (3) of the pro-
gramme selected flashes slowly.

Additional options

You can combine the various dishwashing
programmes with additional options.
Half load
If you choose the option "Half load", only
the cookware in the upper dish rack (13) is
rinsed. In this case, do not fill the lower dish
rack (15). A "Half load" is a good idea when
you have only a small amount of cookware to
wash and want to keep water and electricity
use to a minimum.
Dishwasher operation
9h
6h
3h
Verzögerung
– Press the "Half load" button (8).
The display (11)
option is active.
Delayed start time
The dishwashing process normally starts as
soon as you press the Start/Pause button(12)
. If you want the cycle to begin later, you
can specify this.
1. Switch the dishwasher on using the On/
Off button (2).
2. Select the desired wash programme us-
ing the programme selection button (4).
to
(7)
Verzögerung
(6)
3. Push the Delayed start time button sev-
eral times (6), until the display (7) of your
desired Delayed start time (3, 6 or 9
hours) lights up.
4. Then start the dishwasher, by pressing
the Start/Pause button (12)
The countdown of the Delayed start time
will start and the wash programme begins
automatically when the set time has ex-
pired. The display (7) of the desired De-
layed start time flashes.
Page EN-19
(11)
Start/Pause
(8)
lights up, if this extra
9h
6h
3h
Start/Pause
.