Adding Rinse Aid - Hanseatic WQP8-7610H User Manual

Page EN-12 Dishwasher detergents, rinse aids and dishwasher salts

Adding rinse aid

NOTICE
Risk of damage!
Using an excessive amount of rinse aid
can lead to increased foaming and can
compromise the rinsing results.
Wipe away rinse aid which has over-
■
fl owed immediately.
Take note of the markings for the
■
maximum fi ll quantities ("max") in
the rinse aid chamber.
Using unsuitable substances can cause
damage to the dishwasher.
Only put rinse aids which are suitable for
dishwashers into the rinse aid chamber.
You do not need to add rinse aid to the
dishwasher detergent dispenser
– if you are only using multitabs which al-
ready contain rinse aid.
– if the water hardness in your area is in the
0–5° dH range.
9h
6h
3h
Verzögerung
Add rinse aid before first use and when the
display (10) lights up.
As rinse aid is automatically dispensed during
operation, it ensures that the dishes are spot-
free and accelerates the drying process.
1. Turn the cover of the rinse aid dispenser
(19) a quarter turn in an anti-clockwise
direction and remove it.
2. Fill the water tank to the "max" mark in
the opening. The adjacent display window
will then turn black.
3. Wipe away any rinse aid which has spilt
immediately so that you don't compro-
mise the rinsing results and to avoid in-
creased foaming.
4. We would recommend that you do not
change the dosage that was set by the
factory initially. Only correct the dosage if
you are not satisfied with the rinsing re-
sults (see below).
5. Replace the cover on the opening of the
compartment and turn it in a clockwise
direction.
Amending the rinse aid dosage
If the dishes are
– dull and stained, increase the dosage by
(10)
turning the arrow on the rinse aid dispenser
(19) to a higher value.
– sticky and smeared, decrease the dosage
by turning the arrow on the rinse aid dis-
penser (19) to a lower value.
Start/Pause
(19)