Mounting Of Antenna Units - Furuno NAVnet VX2 Installation Manual

Color video plotter
Hide thumbs Also See for NAVnet VX2:
Table of Contents

Advertisement

1.2 Mounting of Antenna Units

1.2.1 Mounting considerations
When selecting a mounting location for the antenna unit keep in mind the following points.
• Install the antenna unit on the hardtop, radar arch or on a mast on an appropriate
platform. (For sailboats, a mounting bracket is optionally available.) It should be placed
where there is a good all-round view with, as far as possible, no part of the ship's
superstructure or rigging intercepting the scanning beam. Any obstruction will cause
shadow and blind sectors. A mast, for instance, with a diameter considerably less than
the width of the antenna unit, will cause only a small blind sector. However, a horizontal
spreader or crosstrees in the same horizontal plane would be a much more serious
obstruction; place the antenna unit well above or below it.
Antenna unit
Antenna unit
• In order to minimize the chance of picking up electrical interference, avoid where possible
routing the antenna cable near other electrical equipment onboard. Also avoid running the
cable in parallel with power cables.
• Observe the safe compass distances shown in the Safety Instructions to prevent
interference to a magnetic compass.
Typical antenna unit placement on sailboat and powerboat
Antenna unit
4
Antenna unit

Advertisement

Table of Contents
loading

This manual is also suitable for:

1724c1743cGd-1720c

Table of Contents