Vlan Setup - Optical Systems Design OSD2244V Series Operator's Manual

3.4 COMMAND LINE INTERFACE (CLI) FOR VLAN
3.4.1

VLAN SETUP

As mentioned is section 3.3 there are a few steps to note before setting up the OSD2244V VLAN
functions;
Each OSD2244V unit requires VLAN settings to be configured individually
•
When setting up the VLAN configurations the OSD2244V unit should not be connected
•
to any optical fiber or Ethernet cabling.
Refer to section 2.2.5 for USB connections to PC
•
Refer to section 2.5 (Command Line Interface) to enable CLI configurations
•
It is highly suggested to understand the topology and network the user is attempting to
•
achieve before configuring the VLAN settings. A topology diagram such as shown in
Figure 34 is useful when setting the system up. Further diagrams with examples of VLAN
configurations are shown in section 3.6
3.4.2 VLAN CLI COMMAND TABLE
Table 7 is a complete summary of all the CLI commands pertaining to the VLAN functions for the
OSD2244V. It describes the Command description, CLI command, Input format and Function
description. Section 3.5 details each VLAN CLI command with examples.
PAGE 45
OPTICAL SYSTEMS DESIGN
OSD2244V OPERATOR MANUAL
DOC ID: 10111103