The following information regarding VLAN configurations and setups requires knowledge of
the Command Line Interface (CLI) which is described in section 2.5.
3.3.1
CONFIGURATION STORAGE
A non-volatile memory is used to store VLAN configurations for the OSD2244V, therefore all
configurations will be restored back to set values at power on.
3.3.2
CONFIGURATION CHECK
Two CLI commands are available for checking the VLAN settings;
VLAN MODE AND SCHEDULING MODE CHECK - <vmc> Command Line
The VLAN Mode and Scheduling Mode Check is used for checking the configuration of the VLAN
Table.
Current VLAN Mode is: displays the operating mode of the VLAN. There are two possibilities;
1.
Normal – VLAN is disabled
2.
802.1Q VLAN
Current Priority Scheduling Mode is: displays the Schedule mode of the VLAN. There are two
possibilities;
1.
Fixed
2.
Weighted (8:4:2:1)
PAGE 41
OPTICAL SYSTEMS DESIGN
FIGURE 35: VLAN MODE CHECK
OSD2244V OPERATOR MANUAL
DOC ID: 10111103