Table of Contents
Advertisement
10.3 IP CONFIGURATION
The IP can be configured to user requirements/settings. Click "Save" button to save changes.
10.4 VLAN
To Enable VLAN and enable settings, click the Enable VLAN box. Click "Save" button to save
changes. Earlier versions will have the VLAN function permanently enabled.
11 Reset to Factory Default
Changes made to settings, IP, VLAN etc through the GUI are saved when in default position. If for any
reason the unit requires to be reset to factory settings the following command using the CLI (see
section 9) should be used. Note: All previous settings will be erased!
default_setting
Function: Reset configuration to default.
Format: {ds}
PAGE 13
OPTICAL SYSTEMS DESIGN
OSD2258 QUICK START GUIDE
DOC ID: 10117602
Advertisement
Table of Contents
