System Settings - Teltonika GH5200 User Manual

▪ When SIM PIN code is entered correctly user can change PIN code or disable it from the
SIM card. When SIM PIN is disabled and user would like to enable it again, user must
enter the previously used PIN code.
▪ Configuration security keyword can be set to configurator. Keyword can be saved in
configuration file (.cfg), so there is no need to connect the device to the configurator to
configure the keyword. Minimum keyword length is 4 symbols and maximum length is 10
symbols. Only uppercase, lowercase letters and numbers are supported. Keyword can be
configured to .cfg configuration file when the device is not connected.
5.4

System settings

System settings have following configurable parameters:
▪ Sleep Settings, where user can choose a sleep mode;
▪ Records saving settings, where user can enable or disable records when GPS is not
available (no time synchronization);
▪ GNSS Source settings, where user can choose the necessary satellite system(s);
▪ Power On By USB/Charger setting. Device supports two working modes: normal mode,
where the device works as usual, and charging mode, which is entered when Power On By
USB/Charger parameter is disabled. To enter normal mode, device can be turned on by
power button or by USB charger, if Power On By USB/Charger parameter is set to Enable.
▪ Accelerometer Delay Settings, where user can configure movement start and stop delay
values (in seconds);
▪ Time Synchronization settings, where user can choose which source(s) to use for GH5200
time synchronization. User has a choice to: use only one synchronization source (Disable
(GPS only)), allow synchronization from both the GNSS and NTP server (NTP), select
synchronization through GNSS and GSM operator (NITZ) or from all three sources (when
NITZ+NTP is selected). User can select which NTP server (it is possible to configure up to
two servers) and what time period to use to resynchronize time.
▪ Data Protocol setting – allows user to choose which protocol version to be used for data
sending to server.
▪ Sleep Exit Source - allows to select exit from sleep mode method. There are exit sources:
Movement and Alarm button.
Power saving mode is present in GH5200. It allows users to choose from two possible
options:
1. Performance mode – High performance mode, where GNSS module is constantly
awake for a maximum track quality (excluding when GH5200 is in sleep mode).
2. Low Power mode – Battery saving mode, where GNSS module is woken up only
when it is time to acquire position. Standard sleep modes are not available in this
mode. For this mode to function properly, Min Period in "Data Acquisition" tab has
to be >=120 seconds.
Static Navigation mode is a filter, which filters out track jumps when the object is
stationary. If static navigation filter is disabled, it will apply no changes to GPS data. If static
navigation filter is enabled, it will filter changes in GPS position if no movement (as defined by
24