VC LoneWorker Teltonika GH4000 User Guide Changes from Issue 2.02 Section 2.5 (Page 6) Removed notes at end of sub-section. Section 2.6 (Page 6) Removed notes at end of sub-section. Section 2.7.1 (Page 7) Added new sub-sub-section. Issue 2.03 – 22 March 2016...
Emergency alarm button. Start a job / extend a job. End phone call when recording a job or pressed emergency button / switch Teltonika on/off. Lock buttons so they cannot be pressed by accident. Stop current job. Battery indicator.
Check Battery and Signal Strength Press and hold the ‘Start Call’ button (1). The Teltonika will emit an audible beep if you have pressed it correctly. A text message is then sent to the pre-set mobile number (of the lone worker).
NOTE The default duration time of a job is 120 minutes. The VC LoneWorker system sends an SMS text message to the Teltonika to instruct it to start GPS tracking. The Teltonika sends an SMS text message back to the VC LoneWorker system, to confirm that it has started GPS tracking.
Teltonika GH4000 User Guide Track The Teltonika sends a GPS position every 5 minutes on the default configuration during a job. 2.7.1 Notifications The Teltonika can be configured to vibrate for (both Incoming and Outgoing) SMS text messages. We configure the Teltonika to NOT vibrate.
Need help?
Do you have a question about the GH4000 and is the answer not in the manual?
Questions and answers