System Settings - Teltonika FM1110 User Manual

Hide thumbs Also See for FM1110:
Table of Contents

Advertisement

5.8
Stop Detection
Ignition
(recommended)
Msensor (movement
sensor)
GPS
stationary. If Static navigation filter is disabled, it will apply no changes on GPS data. If Static
navigation filter is enabled, it will filter changes in GPS position if no movement is detected
(depends on Object Motion Detection Settings). It allows filtering GPS jumps when object is
parked (is not moving) and GPS position is still traced.
Downloaded from
www.Manualslib.com

System settings

System settings have 7 configurable parameters:
Deep sleep settings, where user can turn deep sleep on or off;
Analog Input Settings, where user can choose analog input range 10 V or 30 V,
depending on needed accuracy (lower range gives higher accuracy of
measurements), and input voltage;
Object Motion Detection Settings, where user can configure 3 ways how FM1110
will detect stopped movement, and change its working mode (for working modes,
read section 5.13);
Static navigation settings, where user can turn static navigation on or off;
Records Settings, where user can enable or disable records when GPS is not
available (no time synchronization);
GNSS Settings, where user can choose satellite system;
Ignition Source sets ignition triggered functionalities to be triggered by:
o Power Voltage (if voltage is between High Voltage Level and Low Voltage
Level the ignition is considered to be turned on);
o Digital Input (DIN1 ON – ignition on, DIN1 OFF – ignition off);
o Movement (if accelerometer/movement sensor detects movement then
ignition is on, if movement stops – ignitin is off).
Source
If ignition (DIN1) is logic low
Internal movement sensor does
not detect movement
GPS fix is available and vehicle
speed is lower than 5 km/h
While GPS fix is unavailable, Object Motion Detection Settings are
working like in Msensor mode
Static Navigation Mode is a filter, which filters out track jumps when the object is
manuals search engine
Vehicle on Stop mode
Vehicle Moving mode
If ignition (DIN1) is logic high
Internal movement sensor detects
movement
GPS fix is available and vehicle
speed is higher than 5 km/h
27

Advertisement

Table of Contents
loading

Table of Contents