Vulcan-Hart GRS25 Service Manual page 33

5. With a 1/2" socket loosen (2) bolts that attach the burner to the mounting frame. (Fig. 41)
6. Slide the heat shield back up to its original position.
7. If the fryer is equipped for filtering the discard tube(s) may need to be disconnect at this point. Refer to steps
1-7 under Removal of Discard Tube(s).
8. With (2) hands grasp the burner body and push it upward over the bullet nose pilot. Then tilt the burner head
back and pull the burner out of the fryer cabinet. (Fig. 42)
9. Reinstall burner by reversing steps 1-8.
Fig. 41
Fig. 42
33