Vulcan-Hart GRS25 Service Manual page 15

REMOVAL OF CONTROL PANEL HOUSING
1. Follow steps 1-2 under Control Panel (Electronic ignition).
2. With a 5/16" socket remove (4) screws holding the housing to the fryer body sides. (Fig. 7)
3. Note and disconnect any wiring harnesses from the housing. If millivolt fryer, pull the thermostat wire
through the access hole in the box. (Fig. 8)
Millivolt construction pull thermostat wire
through the access hole in the box.
4. Pull housing from the fryer.
Fig. 7
Solid state disconnect wire harness.
Fig. 8
15