Vulcan-Hart GRS25 Service Manual page 20

5. Pull the thermistor probe lead from the fryer tank and install new Thermistor probe by reversing
steps 1-6. (See Fig. 12)
REMOVAL OF COMPUTER
1. Follow steps 1-2 under Control Panel (Computerized)
2. Make sure all wire harnesses are disconnected. Remove (6) screw securing the computer to the panel
with a 1/4" socket. (Fig. 17)
3. Install new computer by reversing 1-2. Use loctite and do not over tighten screws.
REMOVAL OF INDICATOR LIGHTS
1. Follow steps 1-2 under Control Panel (Solid State).
2. From the rear of the control panel unscrew the wire cap of light to be replaced.
3. Squeeze the tabs on both sides of the indicator light being replaced and pull the light out through the
front of the panel. (Figs. 18)
4. Reinstall new light by reversing steps 1-3.
Fig. 17
Figs. 18
20