Vulcan-Hart GRS25 Service Manual page 28

REMOVAL OF PILOT
1. Follow instructions for the Removal of Thermopile.
2. With a 1/2" wrench remove the hex nut on the bottom of the pilot and disconnect the pilot tube. (Figs. 33)
3. With an offset flat blade screwdriver remove the pilot assembly bracket from the fryer. (Figs. 33)
4. Install the new pilot by reversing steps 1-4.
REMOVAL OF IGNITOR ASSEMBLY (SOLID STATE AND ELECTRONIC IGNITION ONLY)
1. Follow steps 1- 3 under Control Panel (Solid State Construction).
2. Note and disengage wire harnesses, with a 5/16" socket remove (4) screws securing the control housing
to the fryer and pull the housing off of the fryer. (Figs. 34)
Figs. 33
Figs. 34
28