Table of Contents
Advertisement
OPEARTING MANUAL
6
Operating
After power up the unit the sensor starts an initializing routine for some seconds. During this time the display will show INIT. After this procedure the
object temperature is shown in the display. The display backlight color changes according to the alarm settings [►5.6 Alarms].
6.1
Sensor Setup
The programming keys Mode, Up and Down enable the user to set the sensor on-site. The current measuring value or the chosen feature is
displayed. With Mode the operator obtains the chosen feature, with Up and Down the functional parameters can be selected – a change of
parameters will have immediate effect. If no key is pressed for more than 10 seconds the display automatically shows the calculated object
temperature (according to the signal processing)
Technische Änderungen vorbehalten
0141 0315-100
24.06.2022
Pressing the Mode button again recalls the last called function on the display. The
signal processing features Peak hold and Valley hold cannot be selected
simultaneously
Factory Default Setting
To set the DM back to the factory default settings, please press at first the Down-key
and then the Mode-key and keep both pressed for approx. 3 seconds.
The display will show RESET for confirmation
B+B Thermo-Technik GmbH | Heinrich-Hertz-Str. 4 | D-78166 Donaueschingen
Fon +49 771 83160 | Fax +49 771 831650 | info@bb-sensors.com | bb-sensors.com
65 / 88
Advertisement
Table of Contents
