Table of Contents
Advertisement
TaiShan X6000 Server
User Guide
●
Cable Routing
The X6000 provides various access modes and the management network cabling
methods are as follows:
●
●
Issue 04 (2020-06-05)
–
The iBMC management port to access the HMM in transparent
transmission mode. For details, see
Through the Management Network Port of a Server
On the HMM, users can use:
–
The aggregation network port to access the HMM.
–
The aggregation network port to access the iBMC in aggregated
management mode. For details, see
or WebUI of a Server Node Through the Aggregation Network
Point-to-point cabling
The out-of-band management network cable is routed from a server node
(default configuration in the BIOS), as shown in
In NC-SI mode, the management network cable can also be used as a service network
cable and connected to a service network port.
Figure 3-2 Point-to-point cabling
Aggregation management cabling
A server node is accessed through the aggregation network port over the out-
of-band management network. The network cable is connected to the
aggregation network port, as shown in
The default configuration in the BIOS is the point-to-point cabling. To change it to
aggregation management cabling, see
of a Server Node Through the Aggregation Network
Copyright © Huawei Technologies Co., Ltd.
3 System Architecture and Management
5.3.1.2 Logging In to the HMM CLI
12.1.2 Logging In to the iBMC CLI
Figure
3-2.
Figure
3-3.
12.1.2 Logging In to the iBMC CLI or WebUI
Port.
Node.
Port.
27
Advertisement
Table of Contents
