Table of Contents
Advertisement
TaiShan X6000 Server
User Guide
●
Issue 04 (2020-06-05)
Figure 12-6 Network Settings
ii.
Click Save.
–
Method 2: Enable network port aggregation on the iBMC CLI.
i.
Log in to the iBMC CLI of the server node.
ii.
Run the following command to set the network port mode to the
manual mode:
iBMC:/->ipmcset -d netmode -v 1
Set net mode Manual successfully.
iii. Run the following command to enable network port aggregation:
iBMC:/->ipmcset -d activeport -v 3
Set active port successfully.
Enable network port aggregation on the BIOS.
a.
When the screen shown in
start the BIOS Setup Utility.
Copyright © Huawei Technologies Co., Ltd.
Figure 12-7
is displayed, press Delete or F4 to
12 Common Operations
87
Advertisement
Table of Contents
