Steering Adjustments - MacDon M155 Operator's Manual

7.7.4

Steering Adjustments

7.7.4.1 Steering Link Pivots
The following checks should be performed
annually:
DANGER
Stop engine, and remove key from ignition
before leaving Operator's seat for any reason.
A child or even a pet could engage an idling
machine.
a. Place GSL in N-DETENT, shut down engine, and
remove key.
b. Check for evidence of interference of moving parts
with hoses, tubes, other linkages.
B
A
c. Check steering rod bolts (A) for looseness. and
ball joints (B) for any perceptible play or
movement.
Form 169563 / 169566 / 169568
MAINTENANCE AND SERVICING
A
142
d. Check steering link bolts (C) for looseness, and
ball joints (D) for any perceptible play or
movement.
e. If bolts are loose:
E
F
1. Back off jam-nut (E).
2. Tighten inside nut (F) to 70 - 80 ft·lbf
(95 - 108 N·m).
3. Hold inside nut (F), and tighten jam-nut (E) to
60 - 70 ft·lbf (81 - 95 N·m).
f. If steering link ball joints (B) or steering rod ball
joints (D) are loose, they should be replaced. See
your MacDon Dealer or refer to the Technical
Service Manual for replacement procedures.
g. After replacing parts or making adjustments,
perform checks for Neutral interlock and steering
lock. Refer to Section 7.7.2 Safety Systems.
C
D
Revision B