❷ Use; I Operating Principle; I User Interface Presentation - Zodiac HPO Instructions For Installation And Use Manual

❷ Use

2.1 I Operating principle

2.1.1 General operation
Your heat pump uses the calories (heat) in the air to heat up your pool's water. The process to heat your pool's water to
the temperature you want may take a few days as it depends on the weather conditions, the heat pump's power and the
difference between the water temperature and the temperature you want.
The hotter and more humid the air, the better your heat pump will perform. The outdoor parameters for optimal
operation are an air temperature of 27°C, a water temperature of 27°C and 80% relative humidity.
Tip: to improve the heating and maintaining of your pool's temperature
• Anticipate the commissioning of your pool far enough in advance before you use it.
• For the temperature rise, set the water circulation to continuous operation (24/7).
• To maintain the temperature throughout the season, run "automatic" circulation for the equivalent of the
water temperature divided by two (the longer this time, the more sufficient the operating range of the
heat pump to heat the pool).
• Cover the pool with a sheet (bubble canopy, canvas, etc.) to prevent heat loss.
• The heat pump will be even more efficient if it operates during the warmest hours of the day.
• Keep the evaporator clean.
• Set the temperature you want and let the heat pump run (adjusting the setpoint to maximum will not
heat the water more quickly).
• Connect the "Heating priority"; the filter pump and heat pump's operating time will be set according to
requirements.

2.2 I User interface presentation

Function
"On/off" or "back/exit"
To browse and adjust the values
To select the operating mode: "HEATING", "COOLING" or "HEATING & COOLING" (automatic control)
BOOST To select "BOOST" mode
SMART To select "SMART" mode (default setting)
SILENCE To select "SILENCE" mode
EN
10