Table of Contents
Advertisement
❶ Installation
1.1 I Selecting the location
• The appliance must be installed at 2 metres, minimum, from the surrounding edge of the
pool.
• Do not lift the appliance by the body; use straps (not provided, see § "1.1.1 I Setting up the
device").
• Exercice care during handling of the device. The evaporator (marking
and marking") can be easily damaged.
• The evaporator (marking
sharp edges which can cause injury.
In order to prevent any injury, wear protective gloves during servicing
operations which may involve contact with the evaporator.
• Only an outdoor installation is possible, provide free space around the appliance according to diagram § ''1.2 I
Hydraulic connections''.
• Place the appliance on its anti-vibration blocks (integrated under its base, height adjustable) on a stable, solid and
level surface,
• This surface must be able to bear the weight (voir § 5.2 I "Technical specifications") of the appliance (in particular in
the case of installation on a roof, a balcony or any other support).
View of the appliance base from below for installing the anti-vibration blocks
(MD4 / MD5 / MD7 / TD7 models)
View of the appliance base from below for installing the anti-vibration blocks
The appliance must not be installed:
• With the blowing towards a permanent or temporary obstacle (awning, brushwood, etc.) less than 5 metres away,
• Within range of water or mud jets, sprays or run-off (take the effect of the wind into account),
• Near a heat source or flammable gas,
• Near high-frequency equipment,
• In a location where it would be subject to snow build-up,
• In a location where it might be flooded by the condensates produced by the appliance when operating.
in § "5.3 I Dimensions and marking") may contain
(MD8 / TD8 / MD9 / TD9 models)
in § "5.3 I Dimensions
: front
: rear
: connections
: Anti-vibration blocks
EN
6
Advertisement
Table of Contents
