Novexx Solutions 64 Series Service Manual page 4

Hide thumbs Also See for 64 Series:
Table of Contents

Advertisement

03/02 Rev. 2.14-02
ID
Designation/Function
CN2
Connector operating panel
CN3
Connector power supply
CN5
(only 64-xx Dispenser) Connector limit sensor
for backing paper rewinder
CN6
Connector feed roller sensor (only DPM /
ALX 924 / 64-xx Dispenser)
CN7
Connector material end sensor
CN8
Connector gap sensor
CN9
Connector reflex sensor
CN10 Connector full-size sensor
CN11 Connector single start
CN12 Connector hood switch
CN13 Connector data cable power supply
CN14 Connector data cable output stage
CN15 (only TT4) Connector scanner
CN16 Connector printhead cable
CN17 Programming adapter H8
SERVICE MANUAL
64-xx – CHESS x – DPM – ALX 92x – Novexx PA-1x6
CN18 Connector D-Sub cable harness (4 wires)
CN20 (only DPM / ALX 924) Connection USI board
CON1 Parallel interface (Centronics)
CON2 Serial interface (RS232 / RS485)
CON4 Slot for Compact Flash Card
P3
Pot. 3 Setting feed roller sensor (only DPM /
A.)
P4
Pot. 4 Setting material end sensor
P5
Pot. 5 Setting punch sensor
P6
Pot. 6 Setting reflex sensor
TP4
Test point reflex sensor
TP5
Test point punch sensor
TP6
Test point material end sensor
GND
Earth contact
JP1
Enables Boot Loader overwriting
JP4
5 V supply for printserver at CON1, pin 35
JP9
5 V supply for printserver at CON1, pin 18
Service - Boards, Page 4

Advertisement

Table of Contents
loading

Table of Contents